CDVD-10 CANopen DIN-A valve driver
A new approach to integrate existing hydraulic valves with CANopen®-network.
This unit gives a very cost efficient CANopen® interface individually for each coil. Thanks to it’s design it can be mounted to most valves on the market.
I/O module with CANopen® functionality
The PE552 is a compact and robust 16-bit microcontroller I/O module with CANopen functionality. This unit provides 8 digital inputs and outputs and 4 analog inputs. With 2 separate CAN-ports this device provides also a CANopen gateway to J1939 engine/network according to device profile CiA413. PE552 is mounted in very robust metallic casing and it is therefore suitable to be used in very harsh environments.
Male to female OBD II connectors
Kvaser’s OBD II Extension Cable is a highly durable extension cable of 2,5-15 metres in length with male to female OBD II connectors. The cable is made of high quality thermoplastic rubber to ensure excellent flexibility and resilience. All pins are connected.
DSUB9 female to OBD II (J1962) adaptor
Connects any Kvaser CAN bus interface with a DSUB9 female connector to any vehicle with an OBD II (J1962) connector.
a Power injector for CAN busses
Kvaser DB9-Power Inlet is a power injector for CAN busses from a DC power jack into one female D-SUB9 connector. The Kvaser DB9-Power Inlet also has one unpowered male D-SUB9 connector for connecting to the CAN network.
CAN bus hub with three female and one male D-SUB9 connectors.
Offering an adjustable CAN termination resistor (120/60/0 Ohm) it provides an affordable and safe way of terminating the CAN circuit when using Kvaser interfaces on a development board, as well as powering interface devices without internal power, such as Kvaser’s Blackbird and Memorator series.
Adapter cable for the Kvaser PCIcanx 4xHS and Kvaser PCIcan 4xHS boards
The Q-Cable is a 0.3m (approx. 0.98 ft) long adapter cable for the Kvaser PCIcanx 4xHS and Kvaser PCIcan 4xHS boards. A DSUB male connector connects to the PCIcan board, whilst four DSUB male connectors connect to the CANbus.
D-sub 9 pin, 120 ohm resistor for terminating the CAN bus
Kvaser D-sub 9 pin 120 Ohm termination adapter is a CAN adaptor with a 9-pin male D-Sub connector at one end and a 9-pin female D-Sub socket at the other. Between CAN High (pin 7) and CAN Low (pin 2) there is a built-in 120 Ohm CAN terminating resistor.
A multichannel, programmable Ethernet to CAN/CAN FD interface for DIN Rail mounting
The Kvaser DIN Rail SE400S-X10 is a multichannel, programmable Ethernet to CAN/CAN FD interface for DIN Rail mounting.
